Kitchen visits in and around Seattle: 8:00 am – 8:00 pm, seven days Ring (206) 339-4211 at any hour — the line is staffed 24/7 $89 to diagnose, and it comes back off an approved repair Six price bands published before you pick up the phone Ranges, wall ovens, cooktops, rangetops and hoods — Wolf only Independent: no dealer, no manufacturer tie
Wolf Repair Seattle · WA — home (206) 339-4211
Menu

Coverage · Beyond the City

Wolf Repair in White Center

Conditions here

  • Use Family kitchens, cooked in daily Most of what fails here has simply been used — an electrode, a valve, a sensor — rather than corroded by anything outside.
  • Building Modest mid-century houses A later Wolf range often runs on a circuit added at a remodel, so the power supply is our first measurement on one that will not heat.
  • Access Unincorporated King County Just outside the city, yet the $89 call-out is the same figure as a visit inside Seattle.
Gas range in light oak cabinets with the oven open, one burner stripped and its cap on the counter beside a wrench on a blue towel

White Center lies just past the southern edge of the city, in unincorporated King County, a neighbourhood of modest mid-century houses between West Seattle and Burien. Its kitchens are cooked in every day, and most of what fails in them has simply been used. Wolf Repair Seattle, (206) 339-4211, still measures what reaches the range before it measures anything inside it, because a remodel-era circuit and a failed part produce the same silence.

Measuring what reaches the range

A Wolf dual fuel range wants a grounded 240/208 volt, 60 Hz supply of its own, and Wolf’s installation guide warns that performance may be compromised if that supply is under 240 volts. A house that gained its range in a remodel gained the circuit at the same time, and a circuit healthy enough to light a display is not necessarily carrying the oven properly. So the meter comes out before any panel does.

Low voltage does not announce itself. It shows as an oven that takes far longer to preheat than it once did, that struggles to hold a high setting, or that heats unevenly while the burners above it behave perfectly. Those are the same complaints a tired element or a drifting sensor makes, and the only way to separate them is to read the supply first and the parts second. That order is the one described on our range repair page, and once the cause is known the figure follows the stages on how a Wolf repair quote works. If a part has to be ordered you hear that before you decide, not after.

North across the city line, Delridge is a creek valley inside Seattle, where a narrow townhome kitchen sets a different question for a range visit.

In their words

Told by the people who paid for them

5.0 / 51,575 reviews

  • Door glass fogged and the seal hung loose at the bottom corner. Hinge springs had gone soft, so the door never pulled square. New springs and a gasket, and it shuts properly.

    Fergus D.Capitol HillJul 2025

  • Two burners quit lighting the week we had people over. Another shop had already quoted a whole new spark module. It was one cracked igniter and a spilled-on switch, and he showed me the burnt contact.

    Kirsti M.Sunset HillAug 2025

  • The fan would not switch off unless we pulled the breaker. A speed control had failed closed. He carried one, and showed me the old contacts, welded together.

    Perla V.Miller ParkFeb 2026