Kitchen visits in and around Seattle: 8:00 am – 8:00 pm, seven days Ring (206) 339-4211 at any hour — the line is staffed 24/7 $89 to diagnose, and it comes back off an approved repair Six price bands published before you pick up the phone Ranges, wall ovens, cooktops, rangetops and hoods — Wolf only Independent: no dealer, no manufacturer tie
Wolf Repair Seattle · WA — home (206) 339-4211
Menu

Cost · Seattle, WA

Cost of a Wolf Control Board or Touch Panel

Control board or touch panel

$440–$950

Call-out One $89 charge covers getting a technician to your kitchen and diagnosing the fault in full; approve the repair and that $89 comes off its price.

A Wolf control board or touch panel is the top band on this site, shown above, so it is the one part we prove faulty before ordering. Wolf Repair Seattle, (206) 339-4211, checks power, wiring and the parts the board drives first, because a dead sensor or element can look exactly like a failed board. Approve the work and the $89 diagnosis comes off it.

Close-up of a gas range control panel, oven door lowered and one burner opened up with the cap set aside

Try the breaker first

Before anyone orders a board, do what Wolf’s current dual fuel range guide gives for a control panel that will not respond: switch the range off at its circuit breaker for 20 seconds, then back on. A board that wakes up and stays awake after that did not need replacing. If the panel is dead again within the day, write down what it showed and when, because that pattern is what the diagnosis starts from. The rest of an oven control call is set out on our Wolf oven repair page.

Why boards are blamed more than they fail

A control board reports what the parts around it tell it. When a sensor opens, an element burns through or a harness works loose, the display is where the owner sees it, so the board takes the blame. We measure what it is being told before we condemn it.

In the towers of South Lake Union, where the kitchens have no gas, an induction cooktop or an electric oven depends entirely on its electronics, and this band covers both.

If the controls are fine and the problem is heat escaping round the door, the next page is the door, hinge and seal cost page.

What moves it inside the band

Board or touch panel
The touch panel you press and the board that switches the oven can be separate parts, and only the one that fails is replaced.
What the board was blamed for
A board is often suspected when a sensor, an element or a loose connector is the real cause, and those land in lower bands or cost nothing past the $89.
Access to the controls
A wall oven, a range and a cooktop each reach their controls in a different way, so the time on the job differs.

In their words

Told by the people who paid for them

4.9 / 5830 reviews

  • One element sat on full heat wherever the knob went. A relay had welded shut. He found it in twenty minutes and made no attempt to sell me a whole control.

    Elias K.BallardAug 2025

  • Simmer on the front burner had been useless since we moved in. He set the low-flame screw properly and read the manifold pressure. It holds a low flame now. Small job, treated seriously.

    Russ K.BallardJan 2026

  • Heavy rattle every time it hit top speed, loud enough to hear upstairs. The blower wheel had worked loose on the shaft and was touching the housing. Balanced, tightened, and quiet.

    Mette J.BallardMar 2026

Book it

Tell us the model number and what it is doing

Our kitchen visits keep to 8:00 am – 8:00 pm, seven days, across the city and past its edges, while (206) 339-4211 stays staffed 24/7. The $89 diagnosis is known before anyone sets off, and it is credited back once you approve the repair.

Oven door open on an empty cavity with the bake element across the floor, gas cooktop above