Wolf · Seattle, WA
Cooktop Repair
Gas, induction and electric Wolf cooktops — spark modules, sealed burners, coils and touch controls.
What people call about
The complaints, word for word
- Induction zone cuts out whenever a full pan goes on it
- Burner flame burns yellow and sooty instead of blue
- Sparking carries on clicking long after the burner has lit
- One element sits on full heat no matter where the knob is set
On the visit
What actually gets measured
- Induction inverter temperature and cooling airflow under load
- Spark electrode gap and porcelain condition on gas burners
- Burner port pattern and flame colour at full and low
- Touch control response and relay behaviour on electric coils
Also on the van
What it costs
Six bands, and yours is agreed before anything opens
Flat $89 service call covering the visit and full diagnosis, credited against the repair once you approve it.
Each line is a range because the part and the hours both move with the model and the fault. Your appliance gets one firm number — parts and labour as a single figure — as soon as the diagnosis is done, and no panel comes off until you have said yes to it.
- Igniter or spark module
- $170–$420
- Burner valve or orifice service
- $230–$640
- Oven thermostat or sensor calibration
- $220–$460
- Convection fan or motor
- $280–$670
- Control board or touch panel
- $440–$950
- Door hinge, glass or seal
- $280–$690
For comparison Replacing the appliance instead runs $8,010–$16,950 for a comparable professional range, before installation and ventilation work. Every band above sits a long way under that, which is usually the whole argument for repairing a Wolf rather than retiring it.
In their words
Told by the people who paid for them
5.0 / 5787 reviews
Sparking kept going after every burner had lit. Salt air had got into the electrode on the back right. He replaced it and cleaned the porcelain on the others while he was here.
Charmaine R.
Two zones dropped out together whenever the big pan went on. Airflow under the glass was blocked and the inverter was cooking itself. He cleared the vent path and it ran an hour straight.
Thuy P.
One element sat on full heat wherever the knob went. A relay had welded shut. He found it in twenty minutes and made no attempt to sell me a whole control.
Elias K.
Book it
Tell us the model number and what it is doing
A technician is on the road across Seattle 8:00 am – 8:00 pm, seven days, and the phone is answered 24/7. The service call is a flat $89, quoted before we come out, and it comes off the bill in full if you approve the repair.
